Keeping a bone-dry floor is essential when finishing your basement. Being below grade, basements have water potentially coming in from all directions: seeping in from foundation walls, dripping from plumbing, pouring from services located in the basement (water heater, washer, etc.), and wicking up from the concrete floor.
Before installing your floor covering–the floor that you see and walk on–you will install a subfloor. This subfloor elevates the floor cover and acts as a barrier to moisture seeping upward. You can go either of two ways: build your own subfloor from scratch or install a basement subfloor system.
Scratch-Built Plywood vs. DRICORE: Basics of Construction
As an example, we will look at a major subfloor company, DRIcore vs. a scratch-built plywood subfloor:
1. Plywood System: The Traditional Method
You can create your own subfloor using materials found at your lumber yard or home improvement store: 2×4 sleepers, plastic vapor barrier, rigid foam insulation, and exterior grade 5/8″ plywood. Homeowners and contractors have been creating this system for ages. Despite products like DRIcore being on the market, scratch-built is still a valid, cost-effective way to sub-floor your basement.
2. DRICORE System: The Newer Method
A subfloor system that combines all of those functions in a single unit. DRIcore, which has been around since the mid-1990s, is one such brand of subfloor system.
Instead of using large 4’x8′ sheets of plywood, you handle smaller panels that are close to 2′ by 2′. Each panel is a sandwich of OSB and a moisture barrier such as polyethylene or foam.
As an example, we are considering a basement with low moisture problems and an area of 675 square feet. Ceiling height: 7 feet, 4 inches, typical for basements in older homes. The intended finish flooring will be wall-to-wall carpet.
1. Plywood System
A self-built basement subfloor will always be cheaper than a subfloor system. In this example, I estimate that building your own subfloor will cost about $750, up to $1,000.
2. DRICORE System
Current cost, through The Home Depot, is $6.43 per panel. Panels are 2′ x 2′ square. This means that DRIcore costs about $1.61 per square foot.
DRIcore estimates that 205 squares are needed for this space. Total DRIcore cost is $1,318, not including tax and shipping.
Height: Subfloor Tiles Win
In terms of height, DRIcore and other subfloor systems have got the self-built systems beat hands-down. In our example, the 7 feet, 4 inches will be taken down just about one inch. Self-built systems always are thicker.
Scratch-built plywood subfloor systems can raise your basement flooring between 2 1/4” and 5 1/4″. This is a huge jump when dealing with a basement with a low ceiling, like the one in our example.
DRIcore’s true dimensions are 23.5″ x 23.5″, not 24″ x 24″. This means that a DRIcore square foot is about 96% of a real square foot.
But part of this lost 4% is once again given back in the form of the 1/4″ spacer board you run around the room’s perimeter.
Basement subfloor systems like DriCORE are all about convenience and shaving down subfloor height. Scratch-built are all about saving money
Source: Thespruce.com by Lee Wallender